- 100 ml of Technovit 8100 resin, i.e. 2-hydroxyethyl methacrylate (GMA)
- 0.6 gm of Hardener I (benzoyl peroxide)
- 30 ml of infiltrating solution
- 1 ml of Hardener II
Glycol Methacrylate Embedding for Immunohistochemistry
Technovit Glycol Methacrylate: Technical Information and Help From Heraeus Kulzer.
Embedding in plastic provides many advantages to the histotechnologist. Thinner sections can be made providing improved detail. Better support is given to cellular components, offering improved morphology. Short, straight-forward protocols are available giving minimum processing times. In addition, improved chemistry and protocols are now available that are more antigen-friendly.
This protocol will help get you started with embedding your soft biological samples in Technovit 8100, a GMA kit sold by Energy Beam Sciences. Note the areas in which it deviates from the guidelines for embedding in GMA for morphology only.
Procedure:
Use gentle agitation during fixation, washing, dehydration and infiltration for best results.
Fixation of the biological samples can be done in any way appropriate for the antigen you are seeking. Cold acetone, periodate/lysine/paraformaldehyde, and buffered paraformaldehyde solutions have all been used successfully. Try to keep the sample size small using 10mm x 10mm x 2 mm as a maximum. Fixation should be done for several hours at 4°C.
Wash out the fixative with 6% sucrose solution at 4°C overnight.
Dehydration for GMA embedments does not have to be complete because of GMA's miscibility in water. Use acetone for 1 hour at 4° C changing the acetone at the beginning until it remains clear.
Make up your infiltrating solution from:
Mix using a magnetic stirrer until the benzoyl peroxide is completely dissolved. Store at 4°C in a dark bottle for up to 1 month.
Infiltrate for 6 - 10 hours at 4°C using mild agitation. Vacuum will make infiltration more complete and larger samples should have more infiltration steps over a longer period of time.
Make up your embedding solution from:
Mix for 1 minute using a magnetic stirrer. Use the solution within 10 minutes, before polymerization occurs.
Cover your samples in the embedding molds with this solution. Molds of polyethylene such as the JB-4 molds or Peel-Away molds are most often used. Block holder/adapter in the recess on the mold and add mounting plastic. Begin sectioning with glass or if needed, prepare silanized slides.
